Insulation for Fun and Survival

I ventured up to the shabin this past weekend. The weather was crisp and clear, with the temperature ranging from a high of 32F to something in the 20s overnight. One nice thing about this time of year is that the views get better once the leaves have fallen. I arrived Saturday morning and inside the cabin it was about 40F. I fired up the little heater and got to work finishing the insulation. At the end of the last trip I put up some batts in the walls, just the easy ones I did not need to cut, and had not yet insulated the ceiling. The heater was only able to get the temperature up to about 55F.  If I was going to sleep comfortably that night, I needed to get to work!



I wanted to get the ceiling insulated first, so the first thing I did was to install vents within the rafters. These seem to be made out of the same foam material in which Big Macs used to be packaged. They create an space so that air can flow under the roof from the vents in the eaves up to the peak of the roof. Without that air flow, moisture can be trapped in the space, and moisture ruins the insulation.



Once the vents were stapled in place, then I could start insulating. The insulation in the walls is held in by friction, but the insulation in the ceiling must be stapled to the rafters. This was by far the most arduous part of the process, and it was dark outside before I was done.  However, as soon as all the ceiling insulation was in place, the temperature of the shabin began to rise dramatically. I then spent the rest of the evening finishing the wall insulation and stuffing insulation into all the little nooks and funny shaped spaces.



Morning came with ominous dark clouds moving over head, with occasional snow flakes. During the night, there were high winds and some freezing cold misting rain. However, it was warm and quiet inside the shabin. It eventually got so warm, almost 70F downstairs and 75F up in the loft, that I had to strip the blanket off the bed in the middle of the night. I continued working Sunday morning, framing in the walls for the toilet closet and shower area. The kerosene heater ran out of fuel without me noticing, and I worked inside for 3 hours without the inside temperature dropping noticeably. With the insulation and framing work complete, I am now ready to start on paneling the interior. I have ordered 700 square feet of unfinished white pine, so I expect my next post will show some progress on paneling.