Paneling Begins

I made the trek up to the Shabin again last weekend. This follows a couple of inches of snow we received earlier in the week. I was the first vehicle to travel down our shared private road. The road to our land is 2 miles of ups and downs and hairpin turns. In other words, it was a nail biter.



This was especially true considering the 1500 lbs of wood paneling I was carrying in the back of my truck. At least all that weight kept the rear tires well stuck to the ground. I did not spin the wheels once! For paneling, I am using 5 1/8" wide rustic New England white pine flooring. Flooring for wall? Yes, and I will explain why. The only difference between unfinished pine flooring and unfinished pine paneling is the thickness. Paneling is typically 0.3" and flooring is 0.75" thick. Thicker is better! It feels more substantial when you lean on it, and you can nail a picture right to it. On top of that, flooring costs about the same or less than paneling per square foot.  I believe that is because pine flooring is a widely used product with a decent market, while pine paneling has become a niche product.



The best thing I did to prepare was to buy a pneumatic nailer. This is saving me, because paneling take a huge number of nails and this makes it effortless. I am using this inexpensive Hitachi Brad Nailer and it is has been working great.






The planks are tongue and groove, and I am blind nailing them, meaning that I nail into the tongue part and the groove of the next plank. So, I start at the bottom of the walls and work my way up.



The work is pretty fast for plain walls, but going around obstacles such as outlets and windows slows things down a lot. Much measuring, cutting, and trimming is required. I did luck out on my first outlet. Notice that the top of the lower plank landed just right so that I only had to cut an opening in the one plank above. None of the other outlets were so cooperative.



I am keeping to a rustic look, and I want to avoid putting up much molding. For trimming around the windows, I simply trimmed down some scrap planks and nailed them around the opening.



Here is a finished wall. I had been debating how to finish the wood, and I was leaning towards shellac. However, I recently saw this fantastic cabin featured in Dwell. I think it my the most perfect tiny cabin I have seen.  Its interior is unfinished New England white pine.That settled it for me, and I am leaving the wood unfinished to age as it will. I can get away with things looking rustic here, and it is certainly the cheapest and least effort approach.



This is the frist time I had been to the land in the snow. It is quite pretty and the shabin is very cozy.

After two days and 16 hours of work, I almost finished the downstairs area. I believe the downstairs will end up being harder than upstairs, due to all the windows, outlets, and divider walls. This pace is not has fast as I had hoped for, but not as bad as a feared. I am optimistic that I will finish the paneling during the next two day trip.